Thermador Professional PRO-GRAND PG30 Instructions D'installation page 9

Step 2: Cabinet Preparation
GAS AND ELECTRIC SUPPLY ZONES:
F_G. 3A Gas & E_ectrica_ Supply Zones for AH Gas Ranges
Typical placement shown.
Other placement of
Electrical Supply and
Receptacle within the
Electrical and Gas Supply
Zone is acceptable.
NOTE:
If not already
present, install
gas shut-offvalve
in an easiJy
accessible
location. Make
sure all users
knowwhere and
how to shut off
the gas supply to
the range.
NOTE: The
installershould
inform the
consumer of the
location of the
gasshutzoffvalve.
3/4" Ftex Line to
Appliance
1/2"
NPT 120 VAC Receptacle
(Shown) or Junction
I Box
I .... Centerline of
Electrical
I
2" Maximum
Protrusion from Wait "_
_
a
for Gas Supply
Floor
Model A B C D E
30" 8" 12" 10" 6-1/2" 5ol/4"
36" 10ol/2" 15" 10ol/2" 6ol/2" 5ol/4"
48" 16-1/2" 16" 15-1/2" 6ol/2" 5ol/4"
The All Gas ranges may be con-
nected to the power supply with a
range supply cord (supplied with
range) or by hard-wiring to the power
supply. It is the responsibility of the
installer to provide the proper wiring
components (cord or conduit and
wires) and complete the gas con-
nection as dictated by local codes
and ordinances, and/or the National
Electric Code. The units must be
properly grounded. Refer to Step 6
for details.
The range must be connected
only to the type of gas for which
it is certified. If the range is to be
connected to propane gas, ensure
that the propane gas supply tank is
equipped with its own high pressure
regulator in addition to the pressure
regulator supplied with the range.
(See Step 5.)
NOTE:Any opening in the wall behind the appliance
and any opening in the floor under the appliance
must be sealed.
mMPORTANT:
The cord supplied with gas ranges having electric griddle requires
a NEMA 5-20 receptacle, shown here. Local codes may require
a different wiring method.
NEMA 5z20
RECEPTACLE
PLUG