Thermador Professional PRO-GRAND PG30 Instructions D'installation page 11

Step 3 Unpacking, Moving and Placing the Range
CAUTION
Proper equipment and ad-
equate manpower must be
used in moving the range to
avoid injury, and to avoid
damage to the unit or the
floor. The unit is heavy
and shouJd be handled
accordingJy.
The range has an approximate
shipping weight as shown in
Chart A. The grates, griddle
plate and frame, burner caps,
front kick panel and oven racks
must be removed to facilitate
handling. This will reduce the
weight as shown in ChartA and
allow the range to pass through
30" doorways. See Figs. 2A
and 2B on Page 5. Do not
remove the grill or griddle
assemblies.
Remove the outer carton and
packing material from the ship-
ping base. The all gas ranges
are held to the skid by four (4)
bolts (see Fig. 4 and 5). After
removing the bolts the range
must be lifted and removed from
the skid.
mMPORTANT: Do not lift the
range by the oven door's
handJe, as this may damage
the door hinges and cause
the door to fit incorrectJy to
the oven cavity.
Cha_ A 30" Range 36" Range 48" Range
Shipping Weight 335 Jbs. 444 Ibs. 584 Jbs.
Weight without 285 Ibs. 390 Ibs. 524 Ibs.
packing materials
Without door(s),
burner caps, front kick
panel and oven racks
215 Ibs. 295 Ibs. 395 Ibs.
FIG. 4 - Removat of Two Front
Shipping BoJts
FiG. 5 - RernovaJ of Two Rear
Shipping BoJts
Left Rear ,if'Y"
Shipping
Bolt
!
NOTE: Leave adhesive-backed
foam layer over brushed-metal
surfaces to protect finish from
scratches, until the range is in-
stalled in final position.