Thermador Professional PRO-GRAND PG30 Instructions D'installation page 13

Step 4: Installing Anti-Tip Device
For aH 30" and 36" ranges, an anti-tip device must be installed as per these
instructions.
_, WARNING
RANGE TtPPING HAZARD
AH ranges can tip and injury can result.
To prevent accidental tipping of the range,
attach it to the floor, wall or cabinet by
installing the Anti-Tip Device supplied.
A risk of tip-over may exist if the appmi-
ance is not installed in accordance with
these instructions.
mfthe range is pulled away from the wall
for c_eaning, service or any other reason,
ensure that the Anti-Tip Device is prop-
er_y reengaged when the range is pushed
back against the wall. mn the event of
abnorma_ usage (such as a person stand-
ing, sitting, or _eaning on an open door},
failure to take this precaution can result
in tipping of the range. Persona_ injury
might result from spilled hot _iquids or
from the range itself.
_, WARNING
o ALL RANGES CAN
T_P
o _NJURY TO PER-
SONS COULD RE-
SULT
o _NSTALL ANT_-T_P
DEVICES PACKED
W_TH RANGE
o SEE _NSTALLAT_ON
_NSTRUCT_ONS
WARNtNG
ELECTRICAL SHOCK HAZARD
. Use extreme caution when drilling ho_es
into the wall or floor. There may be con-
cealed electrica_ wires _ocated behind the
wall or under the floor.
. mdentify the e_ectricaL circuits that could
be affected by the installation of the Anti-
Tip Device, then turn off power to these
c ircu its.
. Failure to follow these instructions may
result in e_ectrica_ shock or other per-
sona_ injury.
ATTENTION
PROPERTY DAMAGE
. Contact a qualified installer or contrac-
tor to determine the proper method for
drilling ho_es through the wall or floor
materia_ (such as ceramic the, hardwood,
etc.}
. Do not s_ide the range across an unpro_
tected floor.
. Failure to follow these instructions may
result in damage to wall or floor cover-
ings.
Too_s Needed for Installation of Anti-Tip Device:
• Screwdriver, Phillips • Hammer
• Drill, electric or hand • Pencil or other marker
• Measuring tape or ruler
• 1/8" drill bit (wood or metal wall or floor)
• 3/16" carbide:tipped masonry drill bit (concrete or concrete block wall or floor)
• 3/16" anchors, drywall or concrete, 4 each (not required if mounting bracket is being attached to solid wood or metal)
10