Horizon Hobby E-FLITE Slow Ultra Stick 1.2m Manuel D'utilisation page 9

Transmitter Setup
WARNING: Enable the throttle cut feature. Always engage throttle cut
before approaching the aircraft.
WARNING: Never assign Aux 2 to SAFE Select during transmitter setup
with any model transmitter. If SAFE Select is assigned to Aux 2, the
throttle channel/motor will reverse in ight once SAFE is enabled. Motor
reversing is assigned to Aux 2/channel 7 by default in the Smart ESC.
IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
IMPORTANT: The included receiver has been programmed speci cally for
operation in this aircraft.
Some of the terminology and function locations used in the iX12, iX14 and
†
iX20 programming may be slightly different than other Spektrum AirWare™
radios. The names given in parentheses correspond to the iX12, iX14 and
iX20 programming terminology. Consult your transmitter manual for speci c
information about programming your transmitter.
Pre-Programmed Transmitter Setup Files
To save time when setting up your transmitter for this model, visit
www.SpektrumRC.com to download the latest pre-programmed transmitter setup
les. Locate the le for this model using the item number. Download the correct
model le and install it in your transmitter using an SD card.
1. Go to SpektrumRC.com
2. Hover over Support and click on Support Hub from the menu that appears.
3. Scroll and select your transmitter from the list.
4. Scroll to Quick Links and click on Manuals & Support.
5. Click on the Transmitter Preset Download link.
6. Follow preset model les import instruction for the preset model les.
Dual Rates
Low rate is recommended for the initial ights.
NOTICE: To ensure AS3X technology functions properly, do not lower rate
®
values below 50%. If lower rates are desired, manually adjust the position of the
pushrods on the servo arm.
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting Guide
for more information.
Computerized Transmitter Setup
Start all transmitter programming with a blank ACRO model (perform a model
reset), then name the model.
2 Position switch
Set Dual Rates to HIGH 100%
LOW 70%
Set Servo Travel to 100%
Set Throttle Cut to -100%
DX6e ‡
1. Go to the SYSTEM SETUP (Model Utilities)†
DX6 ‡ (Gen2)
2. Set MODEL TYPE: AIRPLANE
DX7 ‡ (Gen2)
NX6 ‡
DX8e
DX8 (Gen2)
DX9
DX10t
3. Set AIRCRAFT TYPE: (Model Setup, Aircraft Type)†:
DX18
WING: Normal
DX20
iX12
†
iX20
†
NX6
NX8
NX10
Exponential
After rst ights, you may adjust exponential in your transmitter.
Transmitter Telemetry Setup
If the transmitter that you intend to use with this aircraft is not displaying
telemetry data, visit www.SpektrumRC.com and update your rmware. With the
latest rmware installed on your transmitter the telemetry option should now be
functional on your transmitter.
EN
3 Position switch
HIGH 100%
MID 70%
LOW 50%
9