Horizon Hobby E-FLITE Slow Ultra Stick 1.2m Manuel D'utilisation page 6

EN
Horizontal Stabilizer Installation
1. Ensure the control horn is facing up, then slide the horizontal stabilizer (A) on
the rear fuselage tube until the bottom screw holes align.
2. Secure the vertical and horizontal stabilizers using the included
M3 x 22mm thumb screw (B).
3. Connect the 180mm elevator pushrod z-bend to the outermost hole in the
servo arm.
4. Attach the clevis to the third outermost hole of the elevator control horn (see
instructions for clevis connection).
Disassemble in reverse order.
6
A
B
M3 x 22mm
Thumb Screw
Elevator Control Horn
Elevator Servo Arm
Retaining Tube
Pushrod Clevis
Slow Ultra Stick 1.2m