Horizon Hobby E-FLITE Slow Ultra Stick 1.2m Manuel D'utilisation page 4

EN
Model Assembly
Rear Fuselage Section Installation
1. Slide the two fuselage sections together until they click, connecting the front
and rear fuselage sections.
2. Secure the sections together with the two included M2 x 14mm button head
screws. (Use a #1 Phillips screwdriver)
3. The elevator servo plugs have a silver identifying mark. Align these marks and
connect the elevator servo plug to the extension from the receiver. The wire
colors will also align, ensuring correct polarity.
4. Connect the rudder servo plug to the extension from the receiver. These plugs
have no silver mark, use the wire color to align them correctly.
5. Stack the connected plugs and insert them into the retainer.
Disassemble in reverse order.
Main Gear Installation
1. Slide one main gear strut (A) into the slot until it engages the retaining latch.
Firm pressure is required to engage the retention latch.
2. Slide the remaining main gear strut (B) into the opposite slot until it latchs.
Disassemble in reverse order, using a tool such as a at screwdriver to release the
retention latch.
4
A
B
M2 x 14mm
Button-Head
Machine Screw
A
Slow Ultra Stick 1.2m