Télécharger Imprimer la page

Horizon Hobby E-FLITE Slow Ultra Stick 1.2m Manuel D'utilisation page 18

Publicité

Les langues disponibles

Les langues disponibles

EN
Post Flight
1. Disconnect the ight battery from the ESC (required for safety and
battery life).
2. Power OFF the transmitter.
3. Remove the ight battery from the aircraft.
4. Repair or replace all damaged parts.
Motor Service
CAUTION: Always disconnect the ight battery before performing motor service.
Disassembly
1. Remove the spinner (A), screw (B), spinner retainer (C), propeller nut (D) and
propeller (E).
2. Remove the 4 screws (F) from the propeller shaft (G).
3. Remove the propeller shaft from the prop adapter.
4. Remove the 2 screws (H) from the motor mount (I) and the fuselage.
5. Disconnect the motor wires from the ESC wires.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• Install the propeller with the size numbers (11 x 5.5) facing forward.
• Tighten the propeller nut using a 10mm wrench.
• Push the rubber spinner back on to the plastic spinner retainer.
Servo Service
Control Surface
Replacement Servo
Aileron (1)
Elevator (1)
SPMSA345SL
Rudder (1)
Troubleshooting Guide AS3X
Problem
Damaged propeller or spinner
Imbalanced propeller
Motor vibration
Oscillation
Loose receiver
Loose aircraft controls
Worn parts
Irregular servo movement
Trim is not at neutral
Inconsistent ight
Sub-Trim is not at neutral
performance
Aircraft was not kept immobile for
5 seconds after battery connection
Incorrect response to the
Incorrect direction settings in the
AS3X Control Direction Test
receiver, which can cause a crash
Throttle not at idle and/or throttle
trim too high
Aircraft will not respond
Throttle servo travel is lower than
to throttle but responds to
100%
other controls
Throttle channel is reversed
Motor disconnected from ESC
18
Possible Cause
Replace propeller or spinner
Balance the propeller.
Replace parts or correctly align all parts and tighten fasteners as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, clevis, horn and control surface)
Replace worn parts (especially propeller, spinner or servo)
Replace servo
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
No Sub-Trim is allowed. Adjust the servo linkage
With the throttle stick in lowest position. Disconnect battery, then reconnect battery and keep the
aircraft still for 5 seconds
DO NOT y. Contact Product Support for a solution.
Reset controls with throttle stick and throttle trim at lowest setting
Make sure throttle servo travel is 100% or greater
Reverse throttle channel on transmitter
Make sure motor is connected to the ESC
5. Store the ight battery apart from the aircraft and monitor the
battery charge.
6. Make note of the ight conditions and ight results, planning for future ights.
E
D
B
C
A
Description
A345SL 9g Sub-Micro Digital Servo
Solution
Slow Ultra Stick 1.2m
H
I
G
F
Wiring not shown

Publicité

loading