Assembling The Device; Use; Preparing The Carpet - Cleanmaxx VC9388 Mode D'emploi

EN

Assembling the device

For assembly, you will also need a star-headed screwdriver.
Align the
holes

Use

Preparing the Carpet

1. Vacuum the carpet or upholstered furniture which is to be cleaned thoroughly with a
vacuum cleaner. If possible, use a brush attachment to do this.
2. If possible, remove all furniture from the carpet. In the case of large items of furniture
which cannot be moved to one side, place plastic fi lm below or around the feet and
only remove it once the carpet has completely dried after it has been cleaned. The
feet could be damaged by the moisture from the carpet.
3. Check the colourfastness of the carpet or upholstered furniture. Soak a piece
of white fabric with the cleaning solution supplied (see the "Preparing the Device
/ Filling the Fresh Water Container" section) and rub it carefully on an inconspi-
cuous spot on the carpet. If the white fabric does not become discoloured, the carpet
or upholstered furniture can be cleaned with the device. In the case of carpets or
upholstered furniture with several colours, test the fastness of each colour.
18
1. The fresh water tank (3) has already been installed in the
midsection. Remove it before assembly by fi rst depress-
ing the release button (2) and then pulling it out. Mount the
midsection on the main unit as shown.
2. Insert the handle in the opening on the midsection and
align it so that the curved end of the handle is on the back
of the device. The handle will lock into place in the right
position.
3. Screw the 3 enclosed screws into the threading on the
back of the midsection (see fi gure) and tighten them with
a star-headed screwdriver.
4. Turn the hook of the upper cord bracket up.
5. Insert the connecting piece on the bottom of the fresh wa-
ter tank in the ring on the bottom of the midsection. Push
the top part of the tank against the midsection until the
catch audibly locks into place.
your Carpet Cleaner.
You have now assembled