After Use; Cleaning The Device - Cleanmaxx VC9388 Mode D'emploi

EN
2. Completely unwind the mains cord (11) from the hook (10), insert it in the cord brack-
et (14) and connect it with an easily accessible socket whose mains voltage corre-
sponds to the device's technical data.
3. Push the On/Off switch (13) to the I position to turn on the device.
7. Now go over the same strip in reverse. The dirty water will be vacuumed up.
8. Start the next strip slightly overlapping the cleaned carpet strip. Work with even
forward and backward movements up to the other edge of the carpet. In the event of
stubborn dirt, go over a strip of the carpet several times if necessary.
9. Once the dirty water tank (7) fi lls up to the Max mark, it will have to be emptied (see
chapter "After use", section "Cleaning the device").
10. If you would like to empty the dirty water tank, fi ll the fresh water tank or end the
cleaning process, place the device on the cloth you laid out. Turn it off (switch set
to 0) and bring the handle to an upright position.
11. Remove the power plug from the socket.

After Use

• Empty both water containers after each use.
• Allow the freshly cleaned surfaces to dry completely.
• If possible, do not tread on the carpet while it is still damp. If it has to be trodden on,
put down white or colourfast towels and tread on them.
• If cleaning solution has got onto wooden fl oors or furniture, wipe it away.
• Vacuum the dry carpet with a vacuum cleaner. If possible, use a brush attachment
to do this.

Cleaning the device

PLEASE NOTE!
■ Remove the mains plug from the plug socket before cleaning the article.
■ The fi lters may not be cleaned in the washing machine.
■ Only air dry the fi lters and do not in any case use a hair dryer.
■ Do not use any chemical cleaning agents to clean the device. These may damage
the device.
■ Before the device can be stored away, the water containers must be emptied and
rinsed out.
1. Make sure that the mains plug is pulled out.
20
4. Step on the pedal (12) and tilt the handle to a position that
is comfortable for you.
5. Run the device to a corner of the carpet.
6. Push the device forward along the carpet border and
depress the button for emitting the cleaning solution (9).
This will apply and brush the cleaning solution into the
carpet. In the process, walk next to the device. Do not
step on the wet carpet! Once you have arrived at the
other end of the carpet, release the button.