Assembling The Device; Preparing The Device - Cleanmaxx VC9390A Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Make sure that the connecting cable is not squashed, bent or laid over sharp edges
and does not come into contact with hot surfaces. Do not wrap the connecting cable
around the device (danger of the cable breaking).
The device must be switched off when inserting or removing the mains plug. Always
pull the mains plug and never the mains cable to disconnect the device from the
mains power.
Never pull or carry the device by the connecting cable.
Protect the device from heat, naked fl ames, direct sunlight, sub-zero temperatures
and collisions. The basic unit should also be protected from persistent moisture and
wet conditions.
Do not place any heavy objects on the device, the connecting cable or accessories.

Assembling the Device

A cross-head screwdriver is required for assembly.
1. Plug the handle (13) onto the handle pole (12) (Picture A). The handle engages in
the correct position.
2. Screw one of the screws that is supplied with the device into the thread on the back
of the handle and use a cross-head screwdriver to tighten it (Picture B).
3. Insert the fresh water container (5) into the back of the basic unit (Picture C). It must
click into place audibly.
The carpet cleaner is now assembled.

Preparing the Device

Preparing the Carpet
1. Vacuum the carpet or upholstered furniture which is to be cleaned thoroughly with a
vacuum cleaner. To do this, use a brush attachment if possible.
2. Remove all furniture from the carpet if possible. In the case of large items of furniture
which cannot be moved to one side, place plastic fi lm below or around the feet and
only remove it once the carpet has completely dried after it has been cleaned. The
feet could be damaged by the moisture from the carpet.
3. Check the colourfastness of the carpet or upholstered furniture. Soak a piece
of white fabric with the cleaning solution supplied (see "Filling the Fresh Water Con-
tainer") and rub it carefully on an inconspicuous spot on the carpet. If the white fabric
does not become discoloured, the carpet or upholstered furniture can be cleaned with
the device. In the case of carpets or upholstered furniture with several colours, test
the fastness of each colour.
15
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

08727

Table des Matières