Prior To Fi Rst Use; Unpacking The Product Contents; Assembling The Device - Cleanmaxx VC9388 Mode D'emploi

Prior to fi rst use
Before you use the device, you must do the following:
• unpack the product contents,
• assemble the device.

Unpacking the product contents

ATTENTION!
❐ Danger of suffocation! Keep all packaging material out of the reach of children and
animals!
Unpack all parts and make sure that the product contents are complete (see chapter
"Product contents") and check for any damages from transport. If you identify damages to
the components, do not use the device (!), instead contact our customer service centre.

Assembling the device

For assembly, you will also need a cross-headed screwdriver.
Align the
holes
screw
screw
1. The fresh water tank (3) has already been installed
in the midsection. Remove it before assembly by fi rst
pressing the release button (2) and then pulling it out.
Mount the midsection on the main unit as shown.
2. Insert the handle in the opening on the midsection and align
it so that the curved end of the handle is on the back of the
device. The handle will lock into place in the right position.
3. Screw the 3 enclosed screws into the threading on the back
of the midsection (see fi gure) and tighten them with a cross-
headed screwdriver.
screw
4. Turn the hook of the upper cord holder up.
5. Insert the connecting piece on the bottom of the fresh water
tank in the ring on the bottom of the midsection. Push the
top part of the tank against the midsection until the catch
audibly locks into place.
pet Cleaner.
You have now assembled your
18
Car-