Cleanmaxx VC9388 Mode D'emploi page 19

Preparing the Device / Filling the Fresh Water Container
PLEASE NOTE!
■ Only ever pour the cleaning agent supplied with the device or standard carpet
cleaning products for carpet cleaners into the fresh water container.
■ Do not use any cleaning products that produce a lot of foam as excessive foaming
impedes the functioning of the device.
Cleaning the carpet
PLEASE NOTE!
■ Do not use the device as a conventional vacuum cleaner.
■ Turn off the device before you remove a water tank.
■ Always make sure that there is no risk of the device tipping over. The water could
leak out of the water tanks. To stow the device, position the handle in an upright
position so that it locks into place.
■ Do not excessively wet the carpet.
1. Determine where you want to start and stop cleaning without stepping on the area
of the carpet that was just cleaned. We recommend that right-handed persons start
on the right carpet border and left handed persons start on the left carpet border.
Cleaning solution may leak out of device once it is deactivated. For this reason, have
a cloth laid out that you can place the device on after use.
19
1. Hold the fresh water tank (3) by the handle and depress
the release button (2). The tank will be released from the
locking mechanism.
2. Take the fresh water tank out of the device.
3. Unscrew the tank cap and fi ll it with carpet cleaner. Please
follow the dosing instructions for the cleaner.
4. Fill the fresh water tank with warm water (max. 40 °C) up
to the Max mark. Then put the cap back on the tank.
5. Mount the fresh water tank in the midsection. In the pro-
cess, fi rst insert the rubber connecting piece on the bot-
tom of the tank in the ring of the main unit. Then press the
tank against the top part of the midsection until it locks
into place.
EN