Look 785 Huez Manuel page 24

FR
FR
HOSE ROUTING
IMPORTANT : You have two routing options:
the first is an installation where the hose is
pre-connected to the caliper, while the second
involves the hose being connected to the lever.
NOTE : Your bike is designed with the FLAT
MOUNT standard compatible with 140 / 160mm
for the rear. The thickness of the rear dropout at
the caliper mounts is 25mm.
Your 785 Huez is equipped with mounts for
attaching two water bottle cages, one on the seat
tube and one on the down tube. Remove the four M5
screws. Install the water bottle cages (refer to the
corresponding product manual), then grease and
tighten the screws to a torque of 4 Nm.
Caution : Use only the screws provided
!
originally.
ROUTAGE DES DURITES
IMPORTANT : Vous avez deux possibilités de routage, la première est un montage où la
durite n'est pas connectée à l'étrier, quant à la seconde la durite est pré-connectée à
l'étrier.
1- Hose connected to the caliper: Insert the rear
NOTE : Votre vélo est prévu au standard de fixation FLAT MOUNT compatible 140 /
brake hose through the base of the frame, then
160mm arrière. L'épaisseur de la base au niveau des fixations de l'étrier arrière est de
route it up through the down tube and the headset.
25mm.
1/
Durite connectée à l'étrier : Insérer la durite de frein arrière par la base du cadre puis
2- Hose connected to the lever: Insert the hose
remonter la par le tube diagonal et le jeu de direction.
through the headset, then descend through the
down tube to exit through the left base of the frame.
2/ Durite connectée au levier : Insérer la durite par le jeu de direction puis descendre
par tube diagonal pour ressortir par la base gauche du cadre.
3- Remember to slide the 510mm foam tube onto
3/ Penser à enfiler le tube en mousse de 510mm sur les durites.
the hoses.
HYDRATATION
Votre 785 Huez est équipé de fixations pour fixer deux portes-bidons, un sur le tube
de selle et un le tube diagonal.
HYDRATION
Démonter les quatre vis M5. Monter les portes-bidons (se référer à la notice produit
correspondant), puis graisser et revisser les vis au couple de 4Nm.
Attention : Utiliser uniquement les vis livrées d'origine
21
Your bottom bracket is on the T47 85.5mm standard.
Follow the manufacturer's assembly instructions.
Our fork dropouts follow the LOOK conical head
through-axle standard to eliminate any axial and
radial play (torque tightening 11Nm). The 785
Huez is designed to accommodate wheels with a
maximum tire size of 700x32.
.
Inspection and maintenance are crucial for your
safety and the lifespan of your product. A poorly
maintained bike and its components can break or
malfunction, leading to an accident that could result
in death or serious injury.
Despite all the care taken in our manufacturing, if
a defect appears or if a repair is necessary, please
contact your authorized LOOK dealer, bringing the
defective product along with your purchase invoice.
Specify the malfunction to your dealer or contact our
customer support at info@lookcycle.com.
21
BOTTOM BRACKET
IMPORTANT : It is strongly recommended to
consult your nearest authorized LOOK dealer for
more information on compatible bottom brackets.
WHEEL ASSEMBLY
IMPORTANT : Always grease the threads of the
wheel axles before assembly.
MAINTENANCE
For more information
requirements, please visit our website
lookcycle.com in the WARRANTY POLICY >
MAINTENANCE section.
CUSTOMER SERVICE
FR
on maintenance
www.
22