Look 785 Huez Manuel page 16

FR
IMPORTANT INFORMATION
FOR THE ASSEMBLY OF THE SPECIFIC LOOK STEM, PLEASE REFER TO THE CHAPTER DEDICATED
TO THE NEW INTEGRATION OF CABLES IN THE NEW HEADSET.
Caution : LOOK products are designed and
!
optimized to be used by cyclists weighing no
more than 100 kg (220.5 lbs). Road bikes
are designed for use only on paved roads where
the tires should not leave the ground. Jumps are
prohibited.
Warning about counterfeit products : The
!
use of counterfeit products is very dangerous
and can cause serious falls, resulting in
significant or even fatal injuries to you and third
parties.
PRODUCT PRESENTATION
Your 785 Huez assembly has been developed
and designed according to LOOK's engineering
specifications to offer the best power transmission
with a race-oriented geometry ensuring optimal
performance.
These characteristics are made possible through
the integration of components specifically designed
for this frame. They are perfectly compatible with
each other, providing better overall coherence
for increased performance and complete cable
integration.
NOTE : Your 785 Huez frame is designed to be
used with the LOOK LS3 stem and an integrated
headset that incorporates brake cables and
hoses.
For more information, please visit our website
www.lookcycle.com under WARRANTY POLICY
> COUNTERFEIT. For more information on
IMPORTANT INFORMATION to be followed,
please visit our website www.lookcycle.com
under WARRANTY POLICY > IMPORTANT
INFORMATION.
If you are unable to access our website, we
can provide you with our warranty policies in
paper form through your retailer.
The 785 Huez incorporates several innovations with
this new headset including, specifically dimensioned
bearings allowing internal routing in harmony with
spacers, a cable guide under the stem, and the new
stem reference to achieve a smooth assembly.
Key components of your new 785 Huez:
-Semi-integrated stem
-Seatpost at the standard 27.2 mm
-Integrated headset 1 1/8 upper and lower.
-Stainless steel bearings 40.5 internal / 49.5
external, Height 6.5, Angles 45/45
-Axe traversants type X12. Avant 100 mm M12 P1,5
-Thru-axles type X12. Front: 100 mm M12 P1.5 total
length 115 mm. Rear: 142 mm M12 P1.5, total length
160 mm
-Bottom bracket type: T47, 85.5 mm width
-Base height for disc brake caliper attachment: 25
mm
-Maximum tire width: 32 mm
CHECK BEFORE INSTALLATION
-The fork and headset assembly.
-The routing of derailleur cables for the installation
of a mechanical groupset.
-The frame bag, including the components to adapt
your bike for mechanical, electronic, and wireless
configurations.
-The specific through axles.
5
FR
6