Publicité
Les langues disponibles
Les langues disponibles
8. Firmly press the lower
connectors over
their adjacent lower
anchors.
NOTE: Verify that the
connectors are secure,
and the strap is not
twisted.
9. Pull the end of the
lower connector strap
to remove slack.
10. Close the ClickTight
over the lower anchor
strap.
11. Ensure
both gray
ClickTight release
buttons are visible.
NOTE: If it is difficult to
close you may have
removed too much
slack.
Rear-Facing Installation
with LUAS
NOTE: Do NOT install by
this method for a child
weighing more than
15.8 kg (35 lb).
9 Recline indicator is completely within the blue
section for rear-facing, after child is secured.
9 Child restraint cannot be moved front to back or
side to side more than 2.5 cm (1 in) at the belt path.
9 LUAS are routed through ClickTight.
9 Car seat base MUST be flat on vehicle seat and
MUST be parallel to vehicle seat.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps, or use a different
seating location in your vehicle.
8
9
10
11
25
Publicité
