Publicité
Les langues disponibles
Les langues disponibles
Note:
•
The destination to save "AWC" can be specified for each scene file. (
•
If "AWC NG" appears and the indicator stays on or if the indicator lights when a scene file is
changed, retry the steps 1 and 2.
When "MANU" is selected, follow the steps below to adjust the white balance.
Step 1
Select "MANU", and then press the [SEL] but-
ton.
The "WHITE BAL" screen appears.
→
Step 2
Move the cursor to "R-GAIN" or "B-GAIN" and
use the [e] or [f] button to select the white
balance.
11. Synchronization setting [SYNC]
The synchronization state is displayed. The horizontal phase for the external synchronization can
also be adjusted. The internal synchronization is indicated as "INT", and the external synchroniza-
tion is indicated as "EXT2" or "EXT1" as the external synchronization mode.
EXT2 (default): Select this setting when connecting this unit mutually.
EXT1: Select this setting when providing the synchronization signal from another device to this unit.
Adjustment of the horizontal phase in the external synchronization mode
Top screen of SETUP menu
** SET UP **
SCENE FILE
WHITE BAL
SYNC
END
<When connecting this unit mutually>
Step 1
Provide the synchronizing output signal from
the RGB/YPbPr output connector Pin No. 6
(G/L OUT) of the master CCU to the RGB/
YPbPr output connector Pin No. 7 (G/L IN) of
the slave CCU.
34
P2
*FILE1
*MANU
*EXT2
☞ Page 33)
"WHITE BAL" screen
** WHITE BAL **
R-GAIN
B-GAIN
RET END
"SYNC" screen
** SYNC **
....
H PHASE
|
−
RET END
Select the same video format setting for both
CCUs. (☞ Pages 13 and 14)
Step 2
Move the cursor to "SYNC" on the top screen
of the SETUP menu.
....
.... 128
|
+
−
....
.... 128
|
+
−
....
0
+
Publicité
