Publicité
Les langues disponibles
Les langues disponibles
Step 2
Move the cursor to "HIGH" or "LOW" and
adjust the level by pressing the [e] and [f]
buttons.
Important:
•
The "LOW" level cannot be larger than the "HIGH" level.
•
When "SENS UP" is set to "OFF" or "---", "AUTO(L)" is not available.
•
"MANU(L)" and "MANU(H)" are not available when "SENS UP" is set to "AUTO (x2)", "AUTO
(x4)" or "AUTO (x8)".
5. Electronic sensitivity enhancement setting [SENS UP]
The magnification of the electronic sensitivity is selectable from the following:
OFF (default), AUTO (x2), AUTO (x4), AUTO (x8), MANU (x2), MANU (x4), MANU (x8)
Note:
•
When "MANU (x2)", "MANU (x4)" or "MANU (x8)" is selected, set "ELC" to "OFF". (
•
When "GAIN" is set to "OFF" or to a low level, image may become grainy and unstable. In such
a case, adjust the electronic sensitivity.
•
When "SHUTTER" is set to other than "OFF", "---" appears and the electronic sensitivity
enhancement function is not available. (☞ Page 24)
•
When the electronic sensitivity enhancement function is used, time for the image sensor read-
out is elongated to enhance the sensitivity. Therefore, the residual image of a moving subject is
increased in accordance with the magnification of the sensitivity.
6. RGB/YPbPr output signal setting [OUTPUT SEL]
The output signals of the RGB/YPbPr output connector are specified.
RGB (default), YPbPr
7. HDMI output signal setting [HDMI OUTPUT]
The output signals of the HDMI output connector are specified.
YPbPr (422) (default), YPbPr (444), RGB (NOR), RGB (ENH)
☞ Page 22)
25
Publicité
