Panasonic AJ-WM50P Mode D'emploi

Instrucciones de funcionamiento
Before operating this product, please read the instructions carefully, and save this
manual for future use.
Avant d'utiliser l'appareil, lire attentivement ce mode d'emploi, et le conserver a des
fins de reference ulterieure.
Antes de utilizar este producto, lea cuidadosamente las instrucciones y guarde este
manual por si tiene que utilizarlo en el futuro.
SS0316AM0 -PS
Printed in Japan
ENGLISH
Precautions with regard to safety
WARNING
■ Do not use this product near anyone with an implanted cardiac pacemaker.
Radio waves may interfere with the operation of the pacemaker.
■ Do not use this product in an aircraft.
Safety of navigation may be compromised.
■ Do not use this product near an automatic door, fire alarm, or other automatic
control products.
Radio waves from this product may interfere with automatic control systems and
cause malfunctions resulting in accidents.
■ Do not use this product in hospitals or areas with the medical electronic
equipment.
Radio waves from this product may interfere with the medical electronic equipment
and cause malfunctions resulting in accidents.
■ Keep the device, cap, and module holder out of the reach of small children.
The accidental swallowing of the cap may have an adverse effect on the body.
- Consult a doctor in the event that ingestion of the cap is suspected.
Accessories
Cap x 1 (attached to device)
Module Holder x 1
For details on using these accessories, consult the camera operating instructions.
Before Using the Product
• Before using this product, please be aware of the following cases where damage may occur.
- Leakage of your private information via this product
- Illegal operation of your P2 device via this product by a malicious third-party
- Interruption to or halting of the operation of your device via this product by a
malicious thirdparty
Device certifications
This device is certified to conform to technical standards based on the Radio Act so
a radio station license is not necessary for use. However, the Radio Act prohibits the
following acts.
• Disassembly/modification
• Removal or erasing of the standards label attached to the rear of this product
Cautions during use
Please be aware of the following restrictions when using this product.
In the event that these restrictions are not adhered to, Panasonic shall accept no
responsibility whatsoever for accidental damage and the like resulting from the use of
this product or from this being in an unusable state.
• This product is for use as a wireless LAN device only.
• This product can only be used in the country or region of purchase.
Operating Instructions
Mode d'emploi
Wireless Module
Module sans fil
Módulo inalámbrico
AJ-WM50P
Model No.
VQT5M75
• Do not connect to wireless networks for which you do not have user privileges.
Networks for which you have no user privileges (SSID *
an automatic search of the wireless network environment is carried out. This may be
treated as an illegal access attempt.
• Do not use this product with anything other than Panasonic devices.
Loading this product into computers and the like may cause faults or malfunctions.
• Do not use in areas where interference from magnetic fields, static electricity or radio
waves may occur. Using this product in the vicinity of any of the following devices
may lead to signal disruption and a decrease in connection speed.
- Microwave Ovens
- Cordless Digital Telephones
- Locations where wireless LAN devices are concentrated.
- Other devices that utilize radio waves in the 2.4 GHz / 5 GHz range
(Bluetooth supporting devices, wireless audio devices, game consoles etc.)
• Data transmitted using radio waves may be intercepted.
• Attach the protective cap when not using this product for long periods or when
carrying this product, and do not directly touch the connector part.
• Do not place this product in an extremely hot location or where it will be subject to
direct sunlight.
• Do not drop this product or subject it to an impact or excessive force.
• Do not apply liquids to this product or expose it to liquids.
*
1 This is a name used to distinguish specific networks over a wireless LAN.
Communication is possible when the SSID is the same for both devices.
Possible with this Product
By inserting this product, wireless LAN functionality can easily be added to any
Panasonic device that supports the wireless LAN option.
Method of Use
Attach this product to the wireless module connection terminal of a P2 device. For
details of how to attach the product to a P2 device, consult the P2 device operating
instructions or user guide.
Part names
Cap
Does not function even if button is pressed
When this product is not correctly recognized
• Check that this product is firmly inserted as far as possible.
• Re-insert the product.
Contact details for use in the event that the device is not recognized after carrying out
the above actions are displayed on the rear.
Specifications
Power supply 5 V DC (
External dimensions 16 mm (W) x 8 mm (H) x 41 mm (L)
(Excluding the cap) (5/8 inch x 5/16 inch x 1-5/8 inch)
Weight (Excluding the cap) Approx. 4.3 g (0.01 lb)
Antennas temperature Tx1, Rx1
Interface USB 2.0
Standards IEEE802.11a/b/g/n/ac Compliant
Transmission Formats OFDM, DSSS
Frequency Range 2412 MHz - 2462 MHz (channels 1 - 11)
(Channel) 5250 MHz - 5330 MHz (W52, W58)
Data Transfer Speed IEEE802.11ac Max. 433 Mbps
(standard value *
1 ) IEEE802.11n Max. 144 Mbps
IEEE802.11a/g Max. 54 Mbps
IEEE802.11b Max. 11 Mbps
Access Format Infrastructure Mode
Ad Hoc Mode *
Security WPA2-PSK (TKIP/AES)
WPA-PSK (TKIP/AES)
WEP (64 bit/128 bit)
*
1 This is a theoretical speed, and the actual transfer speed may vary depending
on factors such as the usage environment and connection products.
* IEEE802.11n is not supported.
2
Note
Depending on the P2 device into which this product is inserted, some modes may not
function.
) may be displayed when
1
LED
) (power supplied via USB2.0 bus)
2