Heating With Hei-Con Temperature Controller Or Contact Thermometer (Not Hei-Mix D); Cleaning And Maintenance; Transport And Storage - Heidolph MR Hei-Tec Mode D'emploi

E
10 Heating with Hei-Con temperature controller or contact thermometer
(not Hei-Mix D)
Connect the contact thermometer as described in "Set-up". Set the Hei-Con or contact
thermometer to the desired temperature. Next, set the hotplate temperature as described
in Section 3.
Note on heating time:
Higher hotplate temperatures will result in a shorter heat-up period.
Large differences between the hotplate temperature setting and the
selected nominal temperature of the Hei-Con temperature controller or
contact thermometer will result in temperature fluctuations. If such
fluctuation is not desirable, set the hotplate to a lower temperature. This
will lead to a longer heat-up period.
Use a cloth dampened with mild soapy water to clean the housing and the surface of the
instrument.
Note
Do not use chlorine bleach or other chlorine-based cleaning products,
abrasive cleanser, ammonia, steel wool or cleaning products with
metallic components under any circumstances. These will damage the
finish of the instrument.
The instrument is maintenance-free. Should repairs become necessary, please contact an
authorised Heidolph Instruments repair technician. Please contact your Heidolph
Instruments dealer or a Heidolph Instruments representation for more information (see
page 31).
Caution
Unplug the AC power cord before opening the housing.
Prior to transport
Switch the instrument off and unplug the AC power cord.

Transport and storage

CLEANING AND MAINTENANCE

TRANSPORT AND STORAGE
26