Heating Without External Temperature Controller (Not Hei-Mix D) - Heidolph MR Hei-Tec Mode D'emploi

Note:
When reducing the speed to "0", the speed will initially remain at
100 rpm.
Turn the knob to the left again to switch the stirring function off.
9

Heating without external temperature controller (not Hei-Mix D)

The display (C) indicates the set temperature for the hotplate. Use the buttons (D) to
adjust the hotplate temperature between room temperature and 300 °C. Press the Heater
ON/OFF button (E) to start the heater function. A lit green frame around the button (E)
indicates that the heating function is enabled.
The heating function is indicated by a flashing heating symbol
Note:
The jumper plug (J) must be in place. The instrument will not heat
otherwise.
Notes on setting the hotplate temperature:
The contents of the mixing vessel will always have a lower temperature
than the set hotplate temperature due to differences in heat conductivity
of various mixing vessels, the volume of material to be heated, and heat
loss due to radiation.
As a rule of thumb, the hotplate temperature should be 1.5 to 4 times
that of the desired temperature of the medium.
The value should be increased according to the specific heat capacity,
volume and desired temperature of the medium.
Note
Note on heating time:
Higher hotplate temperatures will result in a shorter heat-up period.
25
on the display (C).
E