Yamaha RX-V557 Mode D'emploi page 62

REMOTE CONTROL FEATURES
Switching library codes
You can select the unit you want to operate with the
remote control by entering the library code.
1
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
CODE SET
2
Enter the code number "9991" or "9992" (see
the table below).
The TRANSMIT indicator on the remote control
flashes twice, and the library code is changed.
AMP library
code
(remote
control
setting)
To operate this unit using the
9991 default code.
To operate this unit using an
9992
alternative code.
When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components simultaneously
with the default code setting. In this case, set one of the
alternative codes to operate this unit separately.
Note
You must also make settings for the receiver/amplifier.
60
TRANSMIT
Remote
control ID
(unit
Function
setting,
see
page 56)
ID1
(initial
setting)
ID2
Clearing set up remote control
codes
1
Press an input selector button or
select the component control for which you
want to clear the remote control code.
CD MD/CD-R
DVD DTV/CBL
VCR
2
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
CODE SET
3
Enter the code number "0000".
The TRANSMIT indicator on the remote control
flashes twice, and the remote control code for the
selected component is cleared.
y
• If you do not press any button within 30 seconds after step 2,
the clearing process is canceled. If this happens, start over from
step 1.
• You can clear all setup remote control codes at once by entering
the code number "9990".
to
/
TUNER SLEEP
V-AUX MULTI CH IN
AMP
TRANSMIT