Yamaha RX-V557 Mode D'emploi page 60

REMOTE CONTROL FEATURES
Setting remote control codes
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area. For a complete list of available remote
control codes, refer to "LIST OF REMOTE CONTROL
CODES" at the end of this manual.
The following table shows the default component
(Library: component category) and the remote control
code for each area.
Remote Control Code Default Settings
Library
Input
(component
area
category)
CD CD
MD/CD-R MD
TUNER TUNER
DVD DVD
DTV/CBL –
V-AUX –
VCR –
DVR
–
*1
U.K. and Europe models
*2
Other models
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try to set other YAMAHA remote control code(s).
58
Default
Manufacturer YAMAHA
code
YAMAHA 0005
YAMAHA 0024
*1
0023
YAMAHA
*2
0033
YAMAHA 0098
– –
– –
– –
YAMAHA 0208
– –
1
Press an input selector button or
select the component you want to set up.
CD MD/CD-R
DVD DTV/CBL
VCR
2
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
CODE SET
3
Press the numeric buttons (0 to 9) to enter
the four-digit remote control code for the
component to be used.
Refer to "LIST OF REMOTE CONTROL CODES"
at the end of this manual.
STEREO
1
STANDARD SELECT
5
A SPEAKERS
9
The TRANSMIT indicator on the remote control
flashes twice, and the remote control code for the
selected component is set.
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you wait for more than 30 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
/
TUNER SLEEP
V-AUX MULTI CH IN
AMP
TRANSMIT
MUSIC ENTERTAIN MOVIE
2 3 4
EXTD SUR. DIRECT ST.
6 7 8
B NIGHT STRAIGHT
0 10
ENT.
EFFECT
to