Publicité
Les langues disponibles
Les langues disponibles
Adjusting the low flame
General nozzle table
Gas type
mbar
Natural gas
G20 (E)
Liquefied gas
28-30/
Butane
Propane
G30/G31
All manuals and user guides at all-guides.com
Proceed as follows:
• Open the appliance door. Press the control knob
for the oven in and turn it anti-clockwise to the
maximum setting 265.
The gas burner will light. Hold the control knob
pressed in for around 15 seconds and then let go.
• Close the appliance door. Remove the control
knob.
• Through the gas tap opening in the control panel,
loosen the internal setting screw slightly.
• Replace the control knob and heat the oven for
15 minutes.
• Then turn the control knob to the minimum setting
160.
• Remove the control knob again.
• Now, through the gas tap opening in the control
panel, adjust the internal setting screw until a
correct, stable flame is burning.
Loosen the setting screw to increase the gas flow
or tighten it to reduce the gas flow. The setting is
correct when the low flame is around 3 to 4 mm
high.
In the case of a connection to liquefied gas,
tighten the setting screw.
• Replace the control knob again.
• Make sure that the flame does not go out when
the gas flow is changed quickly from maximum to
minimum and vice versa, and when the appliance
door is opened and closed.
Nozzle no.
Nozzle
Bypass
20
115
Partially
open
75
0.48
37
Burner type
Power
(W)
2,400
Oven burner
2,400
Oven burner
Max. con-
sumption
229 l/h
175 g/h
15
Publicité
