Publicité
Les langues disponibles
Les langues disponibles
Original instructions
1) After the boundary wire installation, you can start using ROBOTIC MOWER
(Please refer to Installation Guide for boundary wire installation).
2) Press POWER ON/OFF until the ROBOTIC MOWER turns on. At first time use,
use the default PIN code "0000" by pressing OK for four (4) times when the
number "0" is blinking. (The PIN code can be changed, please refer to "Setting"
in the Installation Guide).
NOTE : ROBOTIC MOWER will turn off automatically when it does not receive any
input within 30 seconds after it is turned on. When an incorrect password is
entered 7 times, the first digit on the upper left side of the LCD screen displays
the "lock" icon as well as "Input PIN", while the middle of the screen displays "
Password is incorrect 3 chance left". You can press "OK" to re-enter the PIN
immediately or wait for 2 seconds and automatically jump to re-enter the
password. When the incorrect password is entered 10 times, the LCD screen
displays "The motor is locked Wait for 09:59". After 10 minutes, when the
ROBOTIC MOWER is unlocked again, the password can be put in again by
switching to the password input interface in the menu.
3) Press ''START'' then press ''OK'' to start mowing.
4) Press HOME then OK, the ROBOTIC MOWER will go back to the charging
station The ROBOTIC MOWER will work continuously until reaching low battery
power level, after which it will return to the charging station. Once charging is
completed, the ROBOTIC MOWER will automatically resume mowing or it will
stay at the charging station. This will depend on the installed mowing schedule.
24
Publicité
