Trox Technik X-CUBE-Ex Guide D'utilisation page 87

BA-CFD-RLM-ATEX 3.9 – 04/2016
Table 10-1: Maintenance
recommendation
Description
1.0 Fan
1.1 Check deposit, damages, corrosion and fixing
1.2 Check impeller for damage and unbalancing, vibration check
1.3 Check the axial and radial gap
1.4 Check flexible connections for tightness
1.5 Check correct function of AVM
1.6 Check correct function of safety devices (guards)
1.7 Check condensate water drain
1.8 Clean entire unit in order to keep all elements in best working conditions
1.9 Check rotational sense of impeller (for all speeds)
2.0 Check fan function and its readiness for immediate start up
2.1 Motor
2.2 Visual control for dirt, damages, corrosion and correct fixing
2.3 Check rotational sense
2.4 Check bearing noise
2.5 Lubricate bearing (where bearings are re-lubricable)
2.6 Check correct function of safety devices (guards)
2.7 Check tight electrical connections on tight fixing
2.8 Clean entire unit in order to keep all elements in best working conditions
10.4 Maintenance recommendations for Fans RLM-ATEX
 Conduct test run if applicable (see Chapter 8.4).
 Document inspection intervals observed.
English
quarterly cyclic on demand
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
EN-19/24