Publicité
Les langues disponibles
Les langues disponibles
EN
13
14
11
VERSION C
Picture 2.
1
5
6
7
8
9
PULLING SET CONTROLS DESCRIPTION
12
10
9
2
3
4
16
15
11
10
5 EN
4.0
PULLING SET CONTROLS DESCRIPTION
Picture 3.
1
5
6
7
15
1 - Welding system selector:
In position
press the torch button to start welding, and re-
lease to stop.
In position
press the torch button to deliver gas; on re-
lease, wire feed and current are activated; press again to stop wire
feed and current and release to shut off the gas supply.
In position
the welder operates in timed mode; press the
torch button to start the welding phase, which stops automatically
after the time interval as set on the timer potentiometer.
2 - Machine ON indicator lamp
3 - Machine overheating indicator lamp
4 - Wire feed speed control -potentiometer
5 - Spot welding time control potentiometer, from 0.3 to 10
seconds (operating only with selector (Ref. 1 - Picture 2 Page 5. -
Picture 3 Page 5. ) set to position
6 - Wire feed motor acceleration time control potentiometer.
7 - Control potentiometer to regulate time during which weld-
ing power is maintained after the relative shutdown signal. In
practice, at the end of welding, if this time is too short, the wire re-
mains stuck in the bath or protrudes too far from the torch contact
tube; otherwise, if the control time is too long, the wire remains
stuck in the torch contact tube, often causing damage to the latter.
8 - Euro torch connector
9 - Quick connectors for ground clamp
10 - Power switch.
2
3
4
16
8
Publicité
