Porsche Wallbox PWB22E212 Manuel D'utilisation page 42

EN | Charge
Information
Any errors are displayed by red indicator lights on the
Wallbox.
g Refer to chapter "Displays and controls" on page
34.
Charging times
The charging duration can vary depending on the
following factors:
–
Country-specific mains voltage and current
–
Settings to limit the charging current
–
Mains voltage fluctuations
–
Ambient temperature of vehicle and Wallbox.
Charging may take longer at temperatures near
the permitted ambient temperature limits.
– Temperature of the high-voltage battery and the
control unit
– Passenger compartment precooling/heating ac-
tivated
Information
The charging power depends on the mains supply,
the type of the domestic electricity connection and
any other large-scale loads being used. The full
charging power may not be available. Consult a quali-
fied electrician for more information. Porsche recom-
mends using a Porsche partner with trained work-
shop personnel and the necessary parts and tools.
40
Starting, pausing and stopping
charging
Start charging
b The Wallbox is ready for operation.
light turns white
b The desired charging current limit has been se-
lected.
1. Insert vehicle plug into the vehicle charge port
�� Connecting to vehicle...
Indicator light flashes white.
Vehicle plug is automatically locked inside
the vehicle charge port
2. The Wallbox approves charging and begins to
charge depending on the selected authorisation.
g Refer to chapter "Authorisation options" on
page 37.
Control light flashes green.
��
The state of charge is displayed in the over-
view in the My Porsche App.
3. The charging process starts automatically.
Charging with an RFID chip
Risk of injury from RFID
DANGER
sensor for persons with
pacemakers or defibrilla-
tors:
If you wear a pacemaker, keep a distance of 24 in
from the RFID sensor on the design front.
If you wear a defibrillator, keep a distance of 16 in
from the RFID sensor on the design front.
b RFID chip has been registered and added to the
Wallbox's approval list. g Refer to chapter "Log in
to the Wallbox" on page 35.
b The vehicle is connected to the Wallbox and
charging can begin.
Indicator
1. Hold the RFID chip against the RFID sensor on
the design front of the Wallbox.
�� Acoustic feedback occurs upon successful
detection, the authorisation indicator light
briefly turns green and charging begins.
on the design front turns green, g Refer to
2.
chapter "Displays and controls" on page 34.. The
respective state of charge is displayed in the
overview in the My Porsche App.
Pause charging
Information
−
This function is available for vehicles with en-
hanced communication only. Charging can be
paused based on a charging plan in accordance
with the ISO 15118 protocol, e.g. to optimise
power consumption.
The vehicle starts charging again automatically.
The charging process can be stopped on the
vehicle.
− Charging can be cancelled on the vehicle or by
the Wallbox in the event of a malfunction only.
on the design front turns blue, g Refer to chapter
"Displays and controls" on page 34.. The respective
state of charge is displayed in the overview in the My
Porsche App.