STORZ & BICKEL Plenty Mode D'emploi page 61

10. D I S A S S E M B L I N G , C L E A N I N G A N D A S S E M B L I N G
10.4. Disassembling the Filling
Chamber
Push the Filling Chamber Cylinder
upwards out of the Filling Chamber
Housing.
Push out the Filling Chamber Cylinder
Push the lower Screen upwards out of
the Filling Chamber Cylinder.
Push out the lower Screen
10.5. Assembling the Filling
Place the Filling Chamber Cylinder
Lower Screen
into the Filling Chamber Housing from
Filling Chamber above, and turn it so that the flattened
Cylinder
positioning surfaces are located in the
intended orientation within the Filling
Filling Chamber
Chamber Housing. Push the Filling
Housing
Chamber Cylinder in until it latches
into the Filling Chamber Housing.
Make sure the positioning surfaces
are oriented correctly, as shown in the
detailed illustration.
Filling Chamber Cylinder, Filling Chamber
Housing, Positioning Surfaces
Put in the Screen into the Filling Cham-
ber from the topside.
Screw the Filling Chamber Cap with
Cooling Coil and Mouthpiece onto the
Filling Chamber.
61
Chamber