Publicité
Les langues disponibles
Les langues disponibles
7. C O M M I S S I O N I N G A N D O P E R AT I O N
the desired preset temperature has
been reached, the vaporization cycle
can begin.
The current temperature can be read
from the thermometer.
If the temperature falls during vapori-
zation, then it is necessary to press the
auto off release handle again to restart
heating.
For technical reasons it is not
possible to measure the tem-
perature in the Filling Cham-
ber during the inhalation process. The
thermometer measures the tempera-
ture of the heat exchanger, and a cor-
responding calibration displays the re-
spective temperature in the Filling
Chamber during inhalation.
The auto off release handle
may not be fixed in the activa-
tion position (such as by tap-
ing or glueing it down). The manufac-
turer cannot accept any liability
whatsoever for damages caused by
alterations to the device or fixation of
the auto off release handle.
In case you prefer to keep the
PLENT Y standing up instead
of laying it on its side, you can
use the Cleaning Brush as a support,
by inserting the wooden handle in the
screwhole next to the rubber foot, as
shown.
Standing up the PLENTY Hot Air Generator
51
Publicité
