Publicité
Les langues disponibles
Les langues disponibles
7. C O M M I S S I O N I N G A N D O P E R AT I O N
Do not leave the device unat-
tended
during
Place the PLENT Y Vaporizer
only on a hard, heat-resistant, flat, sta-
ble surface, never on soft surfaces or
flammable material. Check whether
the power supply voltage corresponds
to the voltage rating listed on the de-
vice. The power cord and plug must be
in perfect condition. Connect the de-
vice only to a properly installed (electri-
cally grounded) socket.
The manufacturer will not bear any
responsibility whatsoever if this acci-
dent prevention measure is not taken.
Please unplug from the mains socket
to completely disconnect from the
mains power supply.
7.1. Heating Up
Turn the device on with the or-
ange power switch (it is rec-
ommended to fill and attach
the Filling Chamber and Cooling Coil
before warming up the Hot Air Genera-
tor).
The power switch lights up to show
that the heater is operative. If the auto
off release handle has already been
activated, then the heating process be-
gins automatically.
Otherwise the heating process must
be started by pressing the orange auto
off release handle.
The heating process is in progress
when the orange control lamp is lit.
The desired temperature may be set
operation.
with the temperature adjustment
wheel. Warming up the heat exchanger
may take up to 4 minutes, depending
on the temperature set.
Press the auto off release handle to activate
the heating process
49
Publicité
