Kärcher HD 13/35-4 Cage Mode D'emploi page 20

Storing the device
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Care and maintenance
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Maintenance
Safety inspection/ maintenance contract
You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract.
Please take advice on this matter.
Before each use
 Check mains cable.
The mains cable should not have been
damaged (risk of electrical shock). A
damaged mains cable must be re-
placed immediately by an authorised
Customer Service Engineer or an elec-
trician.
 Check the high pressure hose for dam-
ages (risk of bursting).
Please arrange for the immediate ex-
change of a damaged high-pressure hose.
 Check oil level from the oil level display
of the high pressure pump.
Please contact Customer Service im-
mediately if the oil is milky (water in oil).
 Check appliance (pump) for leaks.
3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
Weekly
 Clean filter at the water connection.
 Check tire pressure of wheels (refer to
"Specifications").
After 50 operating hours
 Change oil in the pump.
20
Yearly or after 500 operating hours
Change the oil in the high pressure pump.
 For oil type refer to technical specifica-
tions.
 Turn out the oil drain screw.
 Drain the oil in a collection basin.
 Screw in oil drain plug.
 Fill in new oil slowly until the centre of
the oil level display.
Note
Air pockets must be able to leak out.
Troubleshooting
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
WARNING
Repair work and work on the electrical
components may only be performed by an
authorised customer service.
The indicator lamps display the operating
states (green) and interruptions (red).
Reset:
 Set the appliance switch to "0".
 Wait for a while.
 Set the appliance switch to "I".
Operating status display
 Continuous green:
– The appliance is now ready for operation.
 1x blinking green:
– Operational readiness has expired after
30 minutes.
– The appliance has switched off after 30
minutes of continuous operation (safety
if the high pressure hose bursts).
– 7
EN
Indicator lamp