Deaerating the appliance
Open the water supply.
Unscrew the nozzle.
Press the lever on the hand spray gun.
Switch on the appliance and let it run
until the water exiting from the spray
pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
Operation
DANGER
– The appliance may not be used in areas
where a risk of explosion is present.
– Place the appliance on firm, even surface.
– The high pressure cleaner must not be
used by children. (Risk of accident on ac-
count of improper use of the appliance).
– The water jet coming out of the high
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence hold the
spray pipe and gun firmly.
– Never direct the water jet on to persons,
animals, the appliance itself or electrical
components.
– Risk of injury on account of high pres-
sure water jet and mobilised dust. Wear
protective glasses, protective gloves, a
protective suit, special safety boots and
a middle foot protection.
– The jet must not be directed by the user
at him/herself or at other persons to
clean clothing or footwear.
– Do not use the appliance while other
people are present.
– Risk of hearing impairment. Always use
proper ear-protection aids while work-
ing with the appliance.
– Vehicle tyres/ tyre valves may not be
cleaned with this appliance due the high
water pressure.
– Do not spray materials contains asbes-
tos or other health-hazardous sub-
stances.
– Pay attention to ensure that all screws
of all connecting hoses are tightened
properly.
18
– The lever of the hand spray gun must
not be locked during the operation.
– Do not drive over the main cable or the
high pressure hose.
– Work only with adequate lighting.
Turning on the Appliance
Open the water supply.
Plug in the mains plug.
Set the appliance switch to "I".
Unlock the safety lock at the hand-
spray gun by pressing it.
Press the lever on the hand spray gun.
High pressure operation
WARNING
The water jet that is emitted from the high-
pressure nozzle results in a repulsion power
acting on the hand spray gun. Make sure that
you have a firm footing and hold the trigger
gun and the spray lance with both hands.
Power nozzle
The appliance is equipped with the follow-
ing nozzles:
Power nozzle, 15° spray angle
– High pressure flat spray (15°) for large
dirt areas
Note
To prevent damage due to too much pres-
sure, always position high-pressure jet first
from a greater distance towards object to
be cleaned.
Set working pressure and flow rate
Pull the lever on the handgun.
Set the working pressure and quantity
by turning the pressure/ quantity regula-
tion mechanism at the pump unit.
The working pressure can be read from
the manometer.
Interrupting operation
Release the lever on the trigger gun.
The appliance switches off after 30 sec-
onds.
Use the safety catch to secure the
handgun lever.
Store the hand spray gun and spray
pipe in the accessory mount.
– 5
EN