Kärcher HD 13/35-4 Cage Mode D'emploi page 19

Finish operation
 After operating the water using saline
water (sea water), open the hand spray
gun and rinse the appliance for at least
2 - 3 minutes using tap water.
 Release the lever of the trigger gun.
 Set the appliance switch to "0".
 Shut off water supply.
 Activate hand spray gun until device is
pressure less.
 Use the safety catch to secure the
handgun lever.
 Remove the water inlet hose from the
appliance.
 Pull out the mains plug.
 Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.
Frost protection
Warning
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
Store the appliance in a heated room dur-
ing winter or empty it. During longer breaks
in operation, it is advisable to pump in anti-
frost agents into the appliance.
Drain water
 Screw off water supply hose and high
pressure hose.
 Blow through machine with com-
pressed air.
Flush device with anti-freeze agent
Note
Observe handling instructions of the anti-
freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Push the push handle down and push
the appliance.
Transport by crane
 Connect the lifting device in the center
of the strut to load by crane.
Safety information about cranes
DANGER
Risk of injury due to machine dropping.
– Adhere to the local accident prevention
guidelines and safety notes.
– Check the appliance for crane loading for
damage prior to each transport by crane.
– Check the lifting unit for damage prior to
each transport by crane.
– Only lift up the appliance by this mech-
anism when loading by crane.
– Do not use stop chains.
– Protect the lifting device from inadvert-
ent load release.
– Remove the spray pipe with hand spray
gun as well as loose articles prior to
transporting by crane.
– Do not transport any articles on the ap-
pliance during the lifting process.
– The appliance must only be transported
by properly trained crane personnel.
– Do not stand below the load.
– Ensure that no persons are present in
the immediate vicinity of the crane.
– Do not leave the appliance on the crane
unattended.
Safety check
 Check all screws of the appliance for
tightness; retighten if necessary.
When transporting in vehicles
When transporting in vehicles, secure the
appliance according to the guidelines from
slipping and tipping over.
– 6
EN
Transport
Driving
19