Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Nozzle holder
Assembly
Unpacking the product contents
ATTENTION!
❐ Risk of suffocation! Keep the packaging material away from children and animals.
❐ Make sure that the device is not connected to the mains electricity supply before you
attach or remove the accessories.
Unpack all parts and make sure that the product contents are complete (see chapter
"Product contents and device overview") and check for any damage from transport. If
you identify damage to the components, do not use them (!), instead contact our custo-
mer service centre.
Inserting/removing the suction hose
Inserting/removing the telescopic tube
Adjusting the length of the telescopic tube
A
Two of the suction nozzles supplied can be stored in the nozzle
holder. The holder is clamped to the telescopic tube.
•
Insert the connection piece of the suction hose in the
suction opening on the device. It must audibly lock into
place.
•
To remove the suction hose push the notches on the
connection piece and pull the hose out at the same time.
•
Insert the open end of the handle into the corresponding
opening of the telescopic tube. At the same time twist the
handle gently backwards and forwards. Afterwards, check
the connection for secure seating.
•
To remove the telescopic tube, pull it out of the handle.
•
Pull the slider (A) on the telescopic tube down and set the
desired length.
•
Release the slider and move the tube forward until it locks
into place.
22
Publicité
Chapitres
Table des Matières
