Mounting/Removing Suction Nozzles; Operation - Cleanmaxx CP-CY4503EP-6 Mode D'emploi

Mounting/removing suction nozzles

• Insert the free end of the telescopic tube as far as it will go into one of the suction
nozzles supplied. At the same time twist the nozzle gently backwards and forwards.
• For greater fl exibility the suction nozzles can also be connected directly to the suc-
tion hose without using the telescopic tube.
• To remove a suction nozzle simply pull it out.
• Two of the suction nozzles supplied can be stored in the nozzle holder. The holder
is clamped to the telescopic tube.

Operation

ATTENTION!
❐ During use, always keep the nozzles away from body parts or animals and don't
reach into the nozzles. You/they could be caught in the vacuum cleaner or injured. If
something does get caught in the vacuum cleaner, immediately turn off the device (
push the On/Off switch).
❐ Only turn on the vacuum cleaner once you are sure that all parts have been
completely assembled and that all fi lters are correctly inserted.
❐ To ensure that the mains cable does not heat up during operation, pull at least two
thirds of its entire length out of the device housing before switching on the vacuum
cleaner. In order to avoid damage do not tug out the mains cable as far as it will go
(no further than the red mark on the cable)!
❐ Always turn off the device and pull the mains plug out of the socket before you
change a nozzle or attach or remove any other accessories!
❐ Do not under any circumstances vacuum up the following:
– liquids or wet materials (such as wet carpet shampoo)
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– hard, pointy objects such as larger glass shards
1. If you have not already done so, attach the desired suction nozzle to the telescopic
tube or suction hose (see chapter "Assembly", section "Mounting/removing suction
nozzles" and chapter "Product contents and device overview", section "Suction
nozzles").
2. Pull the mains cable out of the housing, ideally as far as the yellow mark but in any
case no further than the red mark on the cable!
3. Insert the mains plug in a properly installed socket that is easily accessible.
4. Press the On/Off switch to turn the vacuum cleaner on.
5. Move the nozzle over the surface you want to clean. You can pull the vacuum cleaner
like a sled when vacuum cleaning.
6. Set the suction power using the suction power control.
23