Storage; Troubleshooting - Cleanmaxx CP-CY4503EP-6 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Storage

Troubleshooting

If your device no longer functions properly, exhibits damage or requires a spare part,
please contact our customer service centre. For your own safety, do not perform any
repairs yourself.
The following table gives you tips on how to resolve minor problems yourself.
Problem
The
vacuum
cleaner
has
suction power.
The
suction
performance
poor.
The
device
emits dust when
vacuuming.
The mains cable
will not completely
retract.
An
unpleasant
odour
develops
when vacuuming.
For storage you can hook the fl oor nozzle into the holder
on the back of the device (see fi gure) and close down the
telescopic tube as far as it will go.
Store the vacuum cleaner in a cool dry indoor room where
it cannot be reached by children or animals.
Potential cause/solution/tips
Is the mains plug not correctly connected with a socket?
Correct the position of the mains plug.
no
Is the socket defective? Try another socket.
Check the fuse for your mains connection.
Is the suction power set too low on the suction power
control?
Turn the suction power control more towards MAX.
Is the auxiliary air vent on the handle open? Close it.
Is the dust container too full? Empty the container.
is
Are the fi lters heavily laden with dirt? Clean the cyclone
insert, motor fi lters and HEPA exhaust air fi lter.
Is the nozzle, telescopic tube or suction hose clogged?
Turn the device off, pull the mains plug out of the socket
and remove the obstruction (also see chapter "Assembly").
Has the dust container not been closed properly and/or is it
not (properly) inserted in the device? Correct this.
Are the fi lters heavily laden with dirt? Clean the cyclone in-
sert, motor fi lters and HEPA exhaust air fi lter.
The mains cable has not been correctly retracted into the
device. Pull it out a little and press the cable retraction but-
ton
again.
Are you using the device for the fi rst time? An odour often
develops when using new devices for the fi rst time. The
odour should disappear once you have used the device a
few times.
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Z 08485

Table des Matières