Renfert SIMPLEX 3D Manuel D'utilisation page 69

10.3.2 Settings / optimization
By repeatedly pressing the settings/optimization button
following settings:
• Temperature
• Printing speed / flow rate
• Backlight / brightness of the display
• Object fan control
• FMS settings
Changes you make here overwrite the settings in the G-code�
Caution!
In Renfert mode, the printing parameters are stored for a perfect printing result. All of the nec-
essary settings for orthodontic applications are optimally pre-configured and tailored to the
filament. This ensures a high level of process reliability and simplicity. Changing these settings
modifies the pre-installed parameters. In this case, Renfert does not guarantee printing quality.
Temperature:
The nozzle and print bed temperature can be changed via the object fan of the
head� Set the object fan speed� This is unlocked by default� When locked, the
G-code settings cannot be overwritten�
Printing speed / flow rate:
The printing speed and extrusion volume can be changed as a percentage of the
original� Use the reset button to return to the G-code values�
Caution!
In Renfert mode, the printing parameters are stored for a perfect printing
result. All of the necessary settings for orthodontic applications are opti-
mally pre-configured and tailored to the filament. This ensures a high level
of process reliability and simplicity. Changing these settings modifies the
pre-installed parameters. In this case, Renfert does not guarantee printing
quality.
Backlight / brightness of the display:
Changing the brightness of the display backlight�
Object fan control
Set the rotational speed using the slide control or set a minimum/maximum rota-
tional speed using the
10.3.3 Pause next layer
The "pause next layer" function stops printing when printing of the current layer has finished.
Activating the "pause next layer" function:
⇒ Press the button (see Fig. 59).
♦ The "pause next layer" function is activated.
♦ The icon shown changes to
♦ Once the layer is complete, the printer switches to the pause menu�
Deactivating the "pause next layer" function:
⇒ Press the button (see Fig. 59).
♦ The "pause next layer" function is deactivated again.
♦ The icon shown changes to
♦ Printing is resumed without interruption�
/ buttons�
�
�
- 27 -
, you can make successive changes to the
en
Fig. 61
Fig. 62
Fig. 63