Renfert SIMPLEX 3D Manuel D'utilisation page 57

5.5.1 Attaching the filament spool
⇒ Place the filament spool (8) on the filament spool holder (7) in such a way that
the filament can be inserted into the filament sensor from underneath.
Ensure that the filament spool is placed on the filament spool holder in
such a way that the filament can be inserted clockwise into the FMS from
underneath (Fig. 20).
Only use Renfert filaments, as they do not result in any gases during print-
ing that are harmful to health.
If using alternative filaments, ensure that no gases are released during
printing that are harmful to health.
5.6 Loading the filament
A video on this topic is provided under the following link
www.renfert.com/simplex-6-en
5.6.1 Selecting the filament / starting heating
For loading, the extruder must be pre-heated to operating temperature (= printing temperature).
The temperature values f or the extruder (= head temp:) and the print bed (= bed temp:) of four different
filaments are stored in the SIMPLEX 3D printer.
• TEMP1: SIMPLEX study model / working model / multi-use
• TEMP2: SIMPLEX aligner model
• USER1: Freely configurable
• USER2: Freely configurable
Chap. 7.2. explains how you can store customer temperature values for the USER1 and USER2
filaments.
⇒ Select the TEMPERATURE
⇒ Using the filament spool icon
Select the TEMP1 filament for the study model filament that is included with the
delivery�
⇒ Press the extruder icon
♦ On the display, the current temperature and the target temperature change
from gray to white�
⇒ Press the lower left arrow
5.6.2 Drawing in / extruding the filament
⇒ Remove the printer cover� When doing so, pay attention to the
cable of the fan�
⇒ Pull the end of the filament through the safety hole of the
filament spool.
⇒ Cut off the end of the filament in such a way that the filament is
straight without any damage, bends, kinks, or melted parts (Fig. 22).
and via the QR code shown.
menu�
, select the required filament.
to start heating�
until you are back in the main menu�
- 15 -
en
Fig. 20
Fig. 21
Fig. 22