Renfert SIMPLEX 3D Manuel D'utilisation page 68

Printing is complete:
♦ For easier removal of the object, the print bed is automatically lowered a little
and the print head is moved to the home position�
en
♦ A corresponding message is shown on the display. This can be confirmed
with "OK"�
Caution! Danger of burns!
The print head and print bed could still be hot.
Wear protective gloves!
⇒ If necessary, you can use the "AXES" menu to lower the print bed further.
⇒ Remove the object from the print bed� Carefully remove the object with one hand using a slight twisting
motion while holding the print bed with the other hand. If the object is difficult to remove, use the spatula
provided�
Take care not to scratch the Kapton film.
So that removal of the object is as easy as possible, wait until the print bed has cooled.
If necessary, you can also remove the build plate from the printer to remove the object�
To do this, loosen the fixing clasps on the front right and left of the print bed and remove the build plate.
When reinserting, ensure that the build plate has been inserted in the correct end position and that the
fixing clasps are closed.
An incorrectly seated build plate can cause misprints or damage to the printer.
10.3 Actions during USB printing
When printing using a USB flash drive, you can intervene in the following ways:
• : Stop
• : Settings / optimization
• : Pause next layer
• : Pause
10.3.1 Stop
⇒ To cancel printing, press the stop
♦ A confirmation prompt asks you whether you really want to cancel the printing
process�
⇒ To resume printing, press the left arrow
♦ Printing continues without further interruption�
⇒ To cancel printing, press the stop
♦ Printing is stopped immediately�
♦ The print head heating and print bed heating are switched off.
♦ You are in the main menu (Fig. 9).
⇒ Select the AXES
⇒ Move the print bed down a little
up to that point�
Caution! Danger of burns!
The print head and print bed could still be hot. Wear protective gloves!
⇒ Remove the object�
button�
�
button again�
menu (Fig. 9) and the axes icon
(Z+) in order to be able to remove the object that has been printed
- 26 -
in that menu:
Fig. 58
Fig. 59
Fig. 60