Pit Boss PLATINUM PB125OPL Manuel D'instructions page 18

ErH Error Screen
ErL Error Screen
Pellet Error Screen
Igniter Error Screen
Auger Error Screen
Fan Error Screen
PIT BOSS® GRILLS
The Unit Has Overheated, Press and hold the Power Button for three seconds to turn the unit off, and allow grill to
Possibly Due To Grease Fire Or cool. Follow Care and Maintenance instructions. After maintenance, remove pellets, and
Excess Fuel confirm positioning of all component parts. Once cooled, Press and hold the Power Button
for three seconds to turn the unit on, then select desired temperature. If error screen still
displayed, contact Customer Care.
Grill fails to perform start-up Check proper positioning of cooking components. Check hopper for sufficient fuel or if there
cycle is an obstruction in the feed system. Remove pellets and follow Care and Maintenance
instructions. Check grill probe. Confirm if actual temperature is correct and accurate. Follow
Grill will not stay lit
Care and Maintenance instructions if dirty. Check Igniter positioning and that it is heating
up properly. In extreme cold, the grill may require a second start. Turn grill off, wait, then
Auger Not Primed
turn on again. Check fan. Ensure it is working properly. Follow Care and Maintenance
instructions if dirty.
Lack Of Fuel, Poor Fuel Quality Check hopper to check that fuel level is sufficient and replenish if low. Should the quality
of Hardwood pellets be poor, or the length of the pellets too long, this may cause an
obstruction in the feed system. Remove pellets and follow Care and Maintenance
instructions.
Igniter is not working properly, Unplug the unit to power down the unit. Plug in the unit and press and hold the power
not making a connection button for three seconds to start up the unit. If not operating properly, call Customer Care
for assistance or a replacement part.
Igniter failure Igniter needs to be replaced. Contact Customer Care for replacement part.
Auger motor is jammed, not Unplug the unit to power down the unit. Plug in the unit and press and hold the power
making connection button for three seconds to start up the unit. If not operating properly, call Customer Care
for assistance or a replacement part.
Fan is not working properly, not Check fan. Ensure it is working properly and air intake is not blocked. Remove access panel
making a connection (see Electric Wire Diagram for diagram), and check for any damage to the fan wires. Follow
Care and Maintenance instructions if fan blades are dirty.
Unplug the unit to power down the unit. Plug in the unit and press and hold the power
button for three seconds to start up the unit. If not operating properly, call Customer Care
for assistance or a replacement part.
18 WWW.PITBOSS-GRILLS.COM