Publicité
Les langues disponibles
Les langues disponibles
Hopper Assembly
•
The hopper includes a pellet clean-out feature to allow for easy
cleaning and the ability to change out wood pellet fuel flavors.
To empty, locate the pellet clean-out door and door handle on the
back side of the hopper. Lift the door handle to unlock. Place a
clean, empty pail under the clean-out door and pull the door han-
dle to open the drop-chute access plate, allowing the pellets from
the hopper to empty. Once empty, lift the door handle again to
unlock. Push the drop-chute access plate back into place. Push the
door handle down to lock closed. (G)
NOTE: Use a long handled brush or wet/dry vacuum to remove
excess pellets, sawdust, and debris for a complete clean-out
through the hopper screen.
•
Running all pellets out of your auger system is recommended if
your grill will be unused for an extended period of time. This can
be done by simply running your grill, on an empty hopper, until all
pellets have emptied from the auger tube.
•
Check and clean off any debris from the fan air intake vent, found
on the bottom of the hopper. Once the access panel has been re-
moved, carefully wipe off any grease build-up directly on the fan
blades. Use warm soapy water to cut the soot and grease. This
ensures airflow is clean and sufficient to the feed system. (H)
Auger Assembly
•
Turn the knob counter-clockwise and lift the door latch to access
the auger inside the hopper. (I) Disconnect the auger wires from
the controller, then loosen the knobs on either side of the auger. (J)
Pull the auger assembly out of the hopper to service or clean. (K)
GRILL CARE CHEAT SHEET
ITEM
Bottom of Main Grill
Burn Pot
Cooking Grates
Flame Broiler™
Shelves
Grease Bucket
Auger Feed System
Hopper Electric Components
Air Intake Vent
Grill Probe (Sensor) and Shield
PIT BOSS® GRILLS
CLEANING FREQUENCY
CLEANING METHOD
Every 5-6 Grill Sessions
Scoop Out, Wet/Dry Vacuum Out Excess Debris
Every 2-3 Grill Sessions
Scoop Out, Wet/Dry Vacuum Out Excess Debris
After Each Grill Session
Burn Off Excess, Brass Wire Brush
Every 5-6 Grill Sessions
Scrape Main Plate with Slider, Do Not Wash Clean
After Each Grill Session
Cloth & Soapy Water
After Each Grill Session
Cloth & Soapy Water
When Pellet Bag is Empty
Allow Auger to Push Out Sawdust, Leaving
Hopper Empty
Once A Year
Dust Out Interior, Wipe Fan Blades with Soapy
Water
Every 5-6 Grill Sessions
Dust, Cloth & Soapy Water
Every 2-3 Grill Sessions
Cloth & Soapy Water
16
G
H
I
J
K
WWW.PITBOSS-GRILLS.COM
Snapshot this chart
for reference.
Publicité
