–
Full face masks with "PC" or "PC/CC" visors:
I M1
1)
II 1 G IIB T6
II 1D
1)
–30 °C ≤ Ta ≤ +60 °C
Mask/helmet combinations may only be used in hazardous areas with a water
screen.
3.6
Type-identical markings
The facepieces are marked differently:
Front port
Mask/helmet adapter
Mask body
Visor (fire brigade)
Visor frame
Elastic straps
4
Use
4.1
Conditions for use
The mask/helmet combination needs to be carefully adapted to the equipment
wearer (adjustment of the adapter slot and internal helmet components) due to
its structure. The mask/helmet adapter must be easy to adjust.
The following conditions must be met if the full face masks are used with a
respiratory filter or a powered air-purifying respirator:
Instructions for use
|
Panorama Nova
I M1
1)
II 1 G IIA T6
II 1D
P, PE, ESA, RA
S
EPDM or Si
EN 136:1998 CL 3+
CExxxxx (notified body in Europe)
PC, PC/CC or L (Triplex), F
K/rt, K/sw
EPDM or Si
–
The ambient conditions (particularly the types and concentrations of
contaminants) must be known. Use corresponding respiratory filters.
Only use self-contained open-circuit breathing apparatuses or air line
breathing apparatuses in cases where the contaminant is unknown.
–
Only use filtering devices if the air does not directly endanger the health or
life of the user.
–
It must be ensured that the ambient atmosphere cannot change for the
worse.
–
Do not use the filtering devices if contaminants with low warning properties
(low-odour, tasteless, no irritation of eyes and airways) are suspected. A
decreasing protective effect of the filtering device cannot be determined in
this case.
–
Do not use filtering devices for entering unventilated tanks, mines, canals,
etc.
–
Do not use filtering devices in oxygen-enriched atmospheres.
–
The oxygen content of the ambient air must not fall below the following limit
values:
–
At least 17 Vol% oxygen in all European countries except in the
Netherlands, Belgium and the UK
–
At least 19 Vol% oxygen in the Netherlands, Belgium, the UK, Australia
and New Zealand
–
In other countries, observe the applicable national regulations.
4.2
Before first use
Check that the facepiece is leak-tight before using it for the first time (see
Technical Manual 9300782 at www.draeger.com/ifu).
|
en
Use
15