25
26
27
28
Carefully and slowly remove the protective
film from the display and recycle.
Static charge may cause display errors to
appear on the display. These will disappear
automatically after some time.
Double check that all water pipes and the
signal cable from the mixer tap are correctly
connected.
Now plug the power cord into the back of the
water conditioning unit.
Connect the water conditioning unit's power
cable to a socket outlet with residual-current
circuit breaker.
The water conditioning unit starts to work and
makes some noise. This is perfectly normal.
The display shows 'INIT'.
The initialization process can take two to
six minutes. It is possible that water will be
dispensed from the mixer tap.
If the system shows an error message (ERR)
on the display, please refer to the user manual
under 'Troubleshooting' on page 59.
eng
45