Blanco CHOICE Icona Instructions De Montage page 37

6
7
8
24 mm
9
I.
red
19 mm
blue
19 mm
19 mm
II. III.
Hygiene advice:
Do not contaminate water-bearing parts!
Attach the red flexible tube of the mixer tap
to the hot water corner valve (left). Make sure
that a sieve seal has been inserted in the tube
connection.
Secure the flexible tube against twisting during
tightening.
Hygiene advice:
Do not contaminate water-bearing parts!
Connect the T-piece to the cold water corner
valve (right). Do not forget the sieve seal! The
blue flexible tube on the fitting is connected to
the upper end of the T-piece. Make sure that a
sieve seal is inserted in the tube connection.
Secure the flexible tube against twisting during
tightening.
Unpack the water conditioning unit and
connect the middle of the three pre-assembled
hoses to the safety valve.
Make sure that the safety valve does not
fall on the floor!
Before assembly, check if there is a
rubber seal in the hose.
Remove the cover on the front of the water
conditioning unit.
To do this, remove the stickers, then tap the
flap at the top corners. The flap swings out
and can be removed upwards.
eng
37