Assembly
Before assembling the water conditioning unit, the sink with mixer tap and drain set
should always be assembled on the worktop with the worktop positioned on the
base cabinet. This defines the installation space (projecting edges of the basin)
for the water conditioning unit.
For assembly with a BLANCO UNIT, the water conditioning unit is assembled after
the waste separation system (BLANCO SELECT) has been fitted in the base cabinet.
1
4
1
2
3
Unpack the mixer tap and the
water conditioning unit.
After removing the hood (1), all sides can be
folded down - by opening the tab connection -
so that all components are accessible.
Open the upper box (2) and take out the
preassembled safety valve with the hoses.
Make sure that the safety valve does not
fall on the floor!
Remove the upper transport hood (3). The
water conditioning unit can then be removed
from the lower transport tray together with the
protective film by grasping the two ends of the
protective film.
The water conditioning unit's weight is
approx. 25 kg. Have a second person
help you if necessary.
All accessories are in the accessories box (4).
eng
35