Publicité
Les langues disponibles
Les langues disponibles
Installation location
The system should only be installed in permanently frost-protected,
closed rooms (room temperature 16 - 43 °C). The appliance is not
suitable for outdoor installation. Avoid direct sunlight.
The size of the room in which the system is installed must be at least
5 m². If the room has a ceiling height of less than 2 m, the room must
be larger than 5 m².
The system requires constant air exchange in order to prevent the
installation site from heating up due to warm exhaust air. Holes or
slits at the bottom or back side of cabinet (in the bottom area) with
at least 75 cm² for air exchange out of cabinet must be fitted. Add
further cooling slits or ventilation grates if necessary. Required
minimum volume of the base cabinet: 225 litres (0.225 m³);
recommended: 263 litres (0.263 m³). Suggested inside dimensions
of base cabinet: 560 x 562 x 715 mm (L x W x H); recommended: 600 x 562 x 780 mm (L x W x H).
If sufficiently dimensioned openings are provided in an adjacent, sufficiently large volume and a
permanent, sufficient air exchange is guaranteed, the base cabinet may be smaller.
The system requires a level, horizontal surface. Only install the system in an upright position.
The system is not suitable for installation in an area where a water jet could be used.
-
1
2
Important: Fire hazard
The system's cooling circuit contains the CFC-
free refrigerant isobutane (R600a). This is a
natural gas without any harmful effects on
the environment. However, it is flammable
and may be released if the cooling circuit is
damaged. Make sure that no parts of the
cooling circuit are damaged! If the cooling
circuit does become damaged, avoid open
fire and ignition sources and ensure good
ventilation.
Cooling the drinking water:
Please note that after installation, the system
needs time to cool the entire system. The
system needs 1 to 2 days to reach the desired
values.
eng
31
Publicité
