Publicité
Les langues disponibles
Les langues disponibles
eng
12a
12b
12c
I.
II.
40
PH 2
Mounting location of the safety valve:
Allow at least a height of 50 mm gradient
for the drain hose.
Check that the ball valve is open and the lever
is in the direction of flow. The valve must
always be open during operation!
Mount the safety valve holder to the
appropriate height using the screw
provided and snap the safety valve
into the holder.
Shorten and route hose:
Shorten the hose to the required length.
Make sure that the hose is laid with a
constant gradient.
The hose must not sag!
Connect drain hose top:
1. Slide the nut over the hose and firmly push
the connector into the hose. Make sure
the hose is firmly seated on the connector.
Also check if the seal is inserted at the
connection.
2. Now use the nut to screw the upper end
of the hose to the outlet of the safety valve.
Publicité
