Energetics E-101 Mode D'emploi page 5

Assembly and activation
Connecting the computer
Data cable: .Connect .the .data .cable .coming .from .the .equipment .with .the .
one .coming .from .the .computer .[1] .
Mounting: .Attach .the .computer .to .the .mount .on .the .equipment . . Carefully .
slide .the .insert .sleeve .on .the .back .of .the .computer .over .the .mount .on .the .
centre .post .[2] .
Pay .attention .not .do .damage .the .data .cable .when .sliding .the .computer .
housing .over .the .mount .
Hand pulse sensors: .Plug .the .hand .pulse .cable .into .the .connector .on .the .
back .of .the .computer .[3] .
!
Not all models are equipped with hand pulse sensors, in this case
there will be no hand pulse cable!
Power supply: . T he .computer .is .powered .with .two .batteries . . Make .certain .
that .the .batteries .are .inserted .correctly .(polarity .+/–) .
1 2 3 3
Computer activation
The .computer .can .be .activated .by .pressing .the .MODE- key .or .when .the .user .
starts .to .pedal .
The .computer .will .display .the .training .time .
Sleep mode
Should .the .E-101 .not .receive .a .signal .for .more .than .4 .minutes .it .changes .into .
the .sleep .mode . . T he .display .turns .dark . . T o .start .again .press .any .key .or .start .
to .pedal .
All .values .are .reset . .
!
If the computer does not receive a signal for more then 4 minutes
the sleep mode is activated.
GB