Hazard Information - Sartorius Biowelder Total Containment Mode D'emploi

1

Hazard Information

The following information is for the personal safety of operating personnel
as well as the safety of the described product.
Hand injury warning
Never grab hold of anything inside openings during operation .
Noncompliance can lead to serious injury .
In case of emergency, press emergency off button!
This will shut down the machine immediately and will result in a power
failure sequence .
To disconnect the BWTC from the mains supply, remove the power cord
from the machine .
Remove power cord before cleaning .
Never open up the device!
Electrostatic sensitive devices (ESD)
Ground straps, table mats and tools with conducting grips are used to
ground people, to achieve equipotential welding and to prevent
electrostatic discharge . This is always a requisite measure if electronics or
electronic components are handled or mounted .
Make sure that rotating tubes do not pose a safety risk during the
welding process .
Follow the accident-prevention and safety regulations relating to the
specific application .
Ground conductor connections must function perfectly .
The device is not intended for use in/with explosive atmospheres .
A discontinuity during the critical section of the welding process can result
in damage and is to be absolutely avoided . The device will attempt to limit
the damage . It is imperative that you follow the operating instructions .
Read the corresponding Chapter 7 .2 .2 Abort in the critical section
In case of damage, have the device cleaned and examined by an
authorized specialist .
The device must be decontaminated before being sent to suppliers
or manufacturers .
The surface in this area can have very high temperatures .
Skin contact can result in burns | injury .
Avoid direct contact with skin in this area and wear corresponding
protective clothing | equipment .
Always use the blade remover tool (accessory) to remove the blade .
Operating Manual Biowelder
Hazard Information
Total Containment
®
5