Appendix; Copyright; Disposal; Technical Data - Sartorius Biowelder Total Containment Mode D'emploi

9

Appendix

9.1

Copyright

Parts of the device are patented. No part this device may be reproduced,
distributed, translated or transferred, in any form or through any means,
electronically or mechanically, including photocopying, recording or saving
to an information storage and retrieval system, without the previous written
approval of Sartorius Stedim Biotech GmbH.
9.2

Disposal

The manufacturer disposes of the Biowelder
The device must be decontaminated before being sent back to Sartorius
Stedim Biotech .
9.3

Technical data

Type designation
Power connection
Input frequency
Power input
In and out connections
Power connection of fuse
Battery
Operating temperature
Place of use
Transient overvoltage
Pollution degree
Altitude
Humidity
Degree of protection
Weight
External size (L × W × H)
Power cord
* The device is programmed with standard parameter sets for welding C-Flex
AdvantaFlex , PharMed BPT and SaniPure
® ®
These parameter sets have been validated at room temperature.
Operating Manual Biowelder
TC.
®
Biowelder TC, BWTC
®
100 VAC – 240 VAC
50/60 Hz
300 VA
Device plug C14 max. 250VAC
Ethernet jack type RJ45
2 × 3.15 A T (Type FST)
CR2032
+5°C – +40°C *
Indoor (Laboratory)
Overvoltage category II
2
up to 2000 m
80% up to 31°C, linearly diminishing to
50% relative humidity at 40°C, not
condensing
IP20
16.4 kg
555 mm × 261 mm × 269 mm
According to local regulations
minimum 3 × AWG18 or 3 × 0.75 mm
minimum local mains supply voltage
BDF .
™ ™
Total Containment
®
Appendix
2
374,
®
39